HDD/SSD and Fractional Scaling
After installing DeLinuxCo, there are some items that should be set or verified. Items like HDD or SSD, Cache and spin down settings. Also, Display scaling if using high resolution on small screen factor etc.
After Install items
Configure your drive settings for better performance.
Select Disks Application
Select Your Drive from the list on the left.
Select Drive Settings
Select APM Tab and enable.
Select Write Cache Tab and enable
If your drive has the Standby Tab, enable that as well.
If you happen to have a high resolution display in a small screen form factor, sometimes referred to as "retina display", you may have to adjust the desktop look so that items are easily visible and not so small.
In Cinnamon Desktop this can be achieved with just a few settings. For a reference, lets use a 1920X1080 on a 14" laptop.
Step1: Go to System Settings>>Font Selection
Under "Font Scaling Factor" change from 1.0 to 1.2 text scaling. (you can adjust as necessary)
Step2: Adjust Firefox font scaling
Open Firefox and type about:config in the address bar.
Then type "layout.css.devPixelsPerPx" in the search box.
adjust the setting to 1.2 and click the check mark to save. Restart Firefox
Lastly, you can fine tune the panels in Cinnamon by Right Click on the top or bottom panels and adjust as necessary. (Note: the bottom panel is utilizing only the center zone)
Under "Font Scaling Factor" change from 1.0 to 1.2 text scaling. (you can adjust as necessary)
Step2: Adjust Firefox font scaling
Open Firefox and type about:config in the address bar.
Then type "layout.css.devPixelsPerPx" in the search box.
adjust the setting to 1.2 and click the check mark to save. Restart Firefox
Lastly, you can fine tune the panels in Cinnamon by Right Click on the top or bottom panels and adjust as necessary. (Note: the bottom panel is utilizing only the center zone)